Tandberg Data FC420 Bridge Option User’s Guide
Document T6423053-01, Ver. 1, Rel. 0
November 2002
22
FC420 Services Software Commands
SaveConfiguration
(Immediate)
Save the new configuration. If a
firmware restart is required to make
the change, the user is prompted to
confirm the restart. The user can
override the confirmation request by
indicating the override value on the
command line.
saveconfiguration < restart |
nonrestart >
ScsiInitID
Specify the SCSI initiator ID to be used
on the specified SCSI port.
0x07
set scsiinitid [
sb
[0-15]]
get scsiinitid [
sb
]
ScsiPortBusSpeed
Specifies the transfer rate at which the
Fibre bridge will attempt to negotiate
with SCSI devices. The choices are Fast
SCSI, Ultra SCSI, Ultra 2 SCSI, and
Ultra 3 SCSI.
ultra3
set scsiportbusspeed
[
portnumber
[fast | ultra |
ultra2 | ultra3]]
get scsiportbusspeed
[
portnumber
]
ScsiPortList
(Immediate)
List the available SCSI ports and their
status.
scsiportlist
ScsiPortReset
(Immediate)
Resets the specified SCSI bus.
scsiportreset [
sb
]
ScsiPortResetOnStartup
Specify whether the SCSI port should
be reset on power-up.
enabled
set scsiportresetonstartup [
sb
[enabled | disabled]]
get scsiportresetonstartup [
sb
]
ScsiPortSelTimeout
Show the time (msec) that the bridge
waits for a response from a SCSI
device on the selected port after a
selection request.
256 msec set scsiportseltimeout [
sb
[256
| 128 | 64 | 32 | 16 | 8 | 4 | 2
| 1]]
get scsiportseltimeout [
sb
]
ScsiPortSyncTransfer
Specify whether synchronous SCSI
transfers should be negotiated with
devices on the specified SCSI port.
enabled
set scsiportsynctransfer [[
sb
]
[enabled | disabled]]
get scsiportsynctransfer [
sb
]
ScsiPortTaggedQueuing
Specify whether tagged command
queuing is allowed on the SCSI port.
disabled
set scsiporttaggedqueuing [
sb
[enabled | disabled]]
get scsiporttaggedqueuing
[
sb
]
ScsiPortWideTransfer
Specify whether wide SCSI transfers
should be negotiated.
enabled
set scsiportwidetransfer [
sb
[enabled | disabled]]
ScsiTargets
List the SCSI devices that are on the
referenced SCSI bus.
get scsitargets [
sb
]
ScsiTermination
Set the internal termination of the
referenced SCSI port.
enabled
set scsitermination [sb
[enabled | disabled]]
get scsitermination [
sb
]
Command
Description
Default
Syntax