Tandberg Data FC420 Bridge Option User’s Guide
Document T6423053-01, Ver. 1, Rel. 0
November 2002
Configuring FC420 Firmware
11
Creating a Map File for
the FC420
0
Each FC420 Fibre bridge in the library requires a map file to identify
the SCSI devices in the library electronically connected to each Fibre
Channel port on the board.
To create the FC420 Map, perform the following steps:
1
At the
Ready
prompt, type
scsiportlist
and then press
<Enter>
.
This command returns a list of available SCSI ports and their
current status. Valid status values are
OK
and
Failed
.
2
If there are no SCSI bus failures, type
automap
and press
<Enter>
.
The automap command executes.
3
When the
Ready
prompt reappears, type
saveconfiguration
and
press
<Enter>
.
4
When the
Ready
prompt reappears, type
firmwarerestart
and press
<Enter>
.
Making Other
Configuration
Changes
0
The preceding firmware configuration steps are mandatory to ensure
the successful operation of the library. After completing these
procedures, you may want to make other configuration changes by
issuing other service commands.
Service Command List
0
For your convenience, the entire set of service commands for the
FC420 Fibre bridge are listed in the section that follows.
Using the Help Command
0
You can also obtain a list of service commands by typing
help
and then
pressing
<Enter>
.
To get more information about a particular command, type
help
command_name
and then press
<Enter>
. The variable
command_name
is the exact name of the command you want information about.