Tandberg Data FC420 Bridge Option User’s Guide
Document T6423053-01, Ver. 1, Rel. 0
November 2002
18
FC420 Services Software Commands
FcWWName
Sets/displays the current World Wide
Name (WWN) of the Fibre Channel
interface referenced. Each Fibre port
has a unique WWN. The least
significant 6 bits of the WWN are used
as the Ethernet MAC address.
The
set
variant of the command allows
the user to change the last three bytes
of each WWN. Please note, however,
that the most significant bit of the three
bytes must be 1 in order to provide
WWN verification. Also note that the
last bit of each WWN may only be
assigned one of the following values: 0,
4, 8, or C for port 0; 1, 5, 9, or D for port
1; and 2, 6, A, or E for port 2.
Fabric and loop operation is
unpredictable if duplicate WWNs are
used.
10 00 0x,
where x
is the
Fibre
port
number.
set fcwwname [
portnumber
[0
xnn
0
xnn
0
xnn
]]
get fcwwname [
portnumber
]
FibreBridgeModel
Reports the specific FC420 model
information.
get fibrebridgemodel
FibreBridgeName
Specify the 8-character name assigned
to the FC420 bridge.
“........”
set fibrebridgename [
name
]
get fibrebridgename
FibreBridgeTargetLUN
Specify the soft target LUN used by the
FC420 when addressed by the host.
This LUN is taken from NVRAM.
0x7
set fibrebridgetargetlun [0 -
31]
FirmwareRestart
(Immediate)
Reboots the FC420 firmware.
firmwarerestart
Help (Immediate)
Displays a list of available commands.
When the optional command name is
present, detailed command-specific
information is displayed.
help [command name]
IdentifyFibreBridge
Causes the “Fault” LED on the FC420
board to blink continuously until
disabled.
disabled
set identifyfibrebridge
[enabled | disabled]
Get identifyfibrebridge
Info (Immediate)
Displays version numbers and other
product information for key
components within the FC420.
info
Command
Description
Default
Syntax