Tandberg Data FC420 Bridge Option User’s Guide
Document T6423053-01, Ver. 1, Rel. 0
November 2002
16
FC420 Services Software Commands
DisplayEvent
(Immediate)
Displays the current contents of the
event log. The log is filtered by the
current switch settings as described in
the DispEvent section. If the optional
all
is selected, the display filtering is
temporarily suspended and all logged
events are displayed.
displayevent < all >
EccLog
Resets/displays the ECC error
statistics for the Fibre bridge. The
get
command displays the statistics; the
set
command resets the statistic
counters to zero.
set ecclog clear
get ecclog
ErrorLog
Resets/displays the error logs for the
Fibre bridge. The
get
command
displays the logs; the
set
command
resets the logs to zero.
set errorlog clear
get errorlog
EthernetSpeed
Sets/displays the Ethernet speed of the
Fibre connection. If auto is selected, the
current speed of the connection is
indicated in parentheses in the
response to the get ethernetspeed
command.
auto
set ethernetspeed [10 | 100
|auto]
get ethernetspeed
Exit (Immediate)
Exits the current Telnet command line
interface (CLI) session. This command
has no effect during a serial or in-band
CLI session.
exit
FcAck0
Specifies whether ACK0 or ACK1 will
be returned in response to a Class 2
Fibre Channel data frame or sequence.
When enabled, this option sends
ACK0; when disabled, this options
sends ACK1.
disabled
set fcack0 [enabled |
disabled]
get fcack0
FcClass2
Specifies whether the Fibre bridge will
support Fibre Channel Class 2
(Multiplexed) or Class 3 service.
disabled
set fcclass2 [enabled |
disabled]
get fcclass2
FcConnMode
Sets/displays the connection mode for
the FC420 to arbitrated loop or point-
to-point. Applies to all three Fibre
Channel ports on each board.
loop
set fcconnmode [loop | ptp]
get fcconnmode
FcDataRate
Sets/displays the data rate (in GB/s) at
which the Fibre bridge will operate.
auto
set fcdatarate [1gb | 2gb |
auto]
get fcdatarate
Command
Description
Default
Syntax