Press the
<
(2) or
>
(3) key to move the perforation to the desired posi-
tion. Confirm the input by pressing the Set (1) key.
Confirm the input again by pressing the Setup key. The printer is reset to
the initial status.
TearAdj= 00/72"*
Set < > Exit
Online
Setup
2
1
3
4
The correction made – a maximum of approx. 2.5 cm (1") in
each direction – will be retained after switching the printer
off.
Make sure that the set form length corresponds to the
actual length of the forms you are using.
Reference manual
Settings
45