Taktis Incite Fire S3, Руководство по эксплуатации

Страница: 149 / 211

Installation 3
Taktis Fire Control Panel - Installation Manual
Man-1154-In, Revision E01.02
78 of 156
IFAM Connections
Provide IFAM connections to the Fire Routing O/P terminals of the Taktis Fire Control Panel after installing the
Taktis IFAM Module and variations such as the Taktis Network & IFAM Interface Module and Taktis Network,
Ethernet & IFAM Interface Module.
The IFAM Interface Module provides RS485 communications to the Fire Routing O/P terminals of the Main
Back Board when configured. This configuration provides half duplex RS485 connection. If IFAM is not used,
the Taktis Fire Control Panel provides full duplex RS485 across IFAM 1 and IFAM 2 terminals of the IFAM
Interface Module.
Connecting Loop Circuits
Connect Loop circuits to terminal-strip X32 of the Taktis Fire Control Panel.
Terminate unused Loops of the Taktis Fire Control Panel with zero-ohm shorting-jumpers. Connect zero-ohm
shorting-jumpers on the Taktis Fire Control Panel from Loop 1 OUT ( - ) to Loop 1 IN ( - ) and Loop 1 OUT ( + ) to
Loop 1 IN ( + ). The Taktis Fire Control Panel provides a fault signal when unused loops are not terminated.
Addressable loops 1 though 8 of the Taktis Fire Control Panel are monitored.
The figure below illustrates loop connections on Loop 1 of the Taktis Fire Control Panel:
Figure 3-30
Loop Connections
Reference manufacturer specifications for Sensor connections.
=HURõ2KP©VKRUWLQJ MXPSHUV
PXVWEHFRQQHFWHGWR
XQXVHGORRSWHUPLQDOV
5HIHUHQFH(TXLSPHQW/LVW
$SSHQGL[%IRUVSHFLILFSDUW
QXPEHU
/RRS©FRQQHFWLRQ©FRQWDLQLQJ©
VL[©DGGUHVVDEOH©VHQVRUV