Taktis Incite Fire S3, Руководство по эксплуатации

Страница: 137 / 211

Installation 3
Taktis Fire Control Panel - Installation Manual
Man-1154-In, Revision E01.02
66 of 156
Power Supplies
Taktis Fire Control Panels can be equipped with 5.25 Amp or 10.25 Amp Power Supplies. These power
supplies can be set to operate at inputs of 115 VAC or 230 VAC. Both power options include standby battery
operation.
Set Dip Switches on the 5.25 Amp and 10.25 Amp Power Supplies before completing the installation
process. The power supply settings must be performed to establish the optimal charge current for the
standby-batteries.
The 5.25 Amp Power Supply
The 5.25 Amp Power Supply contains a jumper setting for changing from 115 VAC to 230 VAC. Check the
jumper setting prior to wiring and operating the 5.25 Amp Power Supply with the Taktis Fire Control Panel.
Confirm that the 5.25 Amp Power Supply is set for 230 VAC before operating at 230 VAC. Permanent damage
of the power supply will result if the 115 VAC jumper setting exists while operating the power supply at
230 VAC.
The figure below illustrates the location of jumper-J1 on the 5.25 Amp Power Supply of the
Taktis Fire Control Panel:
)LJXUH
Jumper-J1 of the 5.25 Amp Power Supply
WARNING!
Remove Jumper-J1 before operating the Taktis Fire Control Panel at 230 VAC. Failure to remove
Jumper-J1 prior to operating at 230 VAC will cause permanent damage to the 5.25 Amp
power supply.
WARNING!
DANGER: High Voltage present on jumper pins. Remove AC power before changing jumper setting.
To provide 230 VAC operation, remove jumper-J1
from the circuit-board of the power supply.
To provide 115 VAC operation, connect jumper-J1 to
the circuit-board of the power supply.