Taktis Incite Fire S3, Руководство по эксплуатации

Страница: 107 / 211

Overview 2
Taktis Fire Control Panel - Installation Manual
Man-1154-In, Revision E01.02
36 of 156
'XDO/RRS0RGXOH
The Dual Loop Module provides two addressable loops on the Taktis Fire Control Panel. The Dual Loop Module
must be fitted in an available slot C through F of the Main Back Board. Four Dual Loop Modules can be fitted
on the Taktis Fire Control Panel to provide a maximum of 8 addressable loops. The Dual Loop Modules can be
fitted in any available slot on the Main Back Board to provide this operating function. The Dual Loop Module
monitors loop device status and provides status to the LCD Main Processor Board. It holds all device configura-
tions and operates in a stand-alone manner where catastrophic failures occur. The Dual Loop Module talks to
other parts of the fire control panel to maintain the integrity of alarm and fault functions and AS7240-2
requirements.
The figure below illustrates the Dual Loop Module of the Taktis Fire Control Panel:
Figure 2-30
Dual Loop Module
'
%
(
&
$
Key Description
A LED D8 through LED D11 provide the following status
information:
LED D8 Heart Beat for Processor 2
LED D9 Fault status for Processor 2
LED D10 Loop 1 off state when LED ON
LED D11 Loop 2 off state when LED ON
B Edge connector for termination at slot C, D, E and F of the Main
Back Board and slots G, H, J
C Six-position DIP switch S1 for setting the RS485 bus address of
the circuit board.
D Edge connector for termination at slot C, D, E and F of the Main
Back Board and slots G, H, J
E LED 6 through LED 11 provide the following status information:
LED 6 Heartbeat flashes red to identify functional
status of the Dual Loop Module.
LED 7 Rx Comms flashes green to identify receiving
data.
LED 8 Tx Comms flashes green to identify
transmitting data.
LED 9 Fault flashes yellow to identify an error
condition.
LED 10 Input Active LED flashes green to indicate that
the input is active receiving data.
LED 11 Output Active LED flashes red to indicate that
the output is active transmitting data.