Taktis Incite Fire S3, Руководство по эксплуатации

Страница: 146 / 211

Installation 3
Taktis Fire Control Panel - Installation Manual
Man-1154-In, Revision E01.02
75 of 156
DIP Switch Settings
Provide a unique DIP switch setting on optional circuit boards of the Taktis Fire Control Panel. Optional circuit
boards of the Taktis Fire Control Panel must contain a unique binary setting before being fitted to the Main
Back Board. The binary setting of the DIP switch conforms to a specific address location on the Main Back
Board.
Address 32 must be set to off on all DIP switches.
The numeric order of the address setting between circuit boards does not impact operation but, each circuit
board must be assigned a separate address.
The figure below illustrates binary addresses 1 to 15.
Figure 3-26
Binary Addresses
DIP Switch Setting Example
An address of 7 is set when actuators of the DIP switch are “up” on positions 1, 2 and 3.
These settings identify:
• 2
0
for switch position 1, where 2
0
= 1
• 2
1
for switch position 2, where 2
1
= 2
• 2
2
for switch position 3, where 2
2
= 4
The binary address for this DIP is 1 + 2 + 4 = 7
The figure below illustrates settings for an address of 7 on the DIP switch:
)LJXUH
DIP Switch Settings
The black portion of the DIP identifies the switch actuator. The arrow in the figure above identifies the on
position of the DIP when the switch actuator is in the “up” position.
21