TAJIMA TCMX 601, Руководство пользователя

Страница: 124 / 130

Supplemental documentation
15-5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
SOLENOID
A kind of drive devices when the power is turned on, and it is a kind of products for which electric magnet is applied
SPEED CODE
Design data code to switch setting for embroidery speed (high speed/low speed)
STEP
Sequence of color changes for one design
STEP
To advance value one by one
STITCH DATA
It is set at every one stitch. It consists of X//Y data, function code, and speed code.
STOP AT LOWER D. POINT (PSEUDO-FIXED POSITION)
To stop the machine with needle stuck in cloth at end of embroidery (end code 2) (Stop at the lower dead point
T
TABLE OFFSET
It means to move the frame temporarily to the rear direction to facilitate threading. It is convenient to use this function when the
frame is positioned at table cut section.
TAJIMA COMPLEMENT ERROR
Error related to composition of X and Y data (10 values: +/-1, +/-3, +/-9, +/-27, +/-81) of design data for Tajima embroidery
machine. It means two values that are complemental each other (for example, +27 and -27) exist on X or Y
TAJIMA TWO-WAY NETWORK SYSTEM
System that performs centralized control of plural machines using a personal computer. It can transmit design data or receive run-
ning condition of each machine.
TBF
Abbreviation of Tajima Binary Format
This format can correspond to more function codes compared with DST (Tajima format). It is also possible to store embroidery
conditions of design data (needle bar setting, start position of design etc.).
THE NUMBER OF STITCHES
The number of needle sticks when embroidering
TIE STITCHING
It means stitching that prevents fray of thread. It is executed at thread trimming.
TUBULAR GOODS FRAME
A kind of embroidery frames. It mainly holds trainer, T-shirt, etc. to be stretched.
U
UBC
Abbreviation of Under thread Bobbin Changer. Refer to BOBBIN CHANGER.
UNDER THREAD RELEASE
Action that makes the frame perform slight reciprocating movement to pull out under thread for loosening its tension before thread
trimming not to trim under thread by other sections than the thread trimming section
USB
Abbreviation of Universal Serial Bus. Spec. name of data bus that connects an embroidery machine and a key board, mouse etc.
V
VERSION NUMBER
The number that shows developing order of software or hardware of the machine
W
WEAK BRAKE
A weak brake to hold the main shaft at the fixed position when the machine stops normally with power turned ON
WRITE DESIGN NUMBER
Memory registration number to set for data management when design data is written (memorized)
X
X DATA
The data that makes the embroidery frame move right/left direction (X direction) by the X-axis drive system. The value displayed
as X data indicates movement amount (mm), and the symbol indicates movement direction (+left, -right)
X-AXIS DRIVE SYSTEM
The drive system that makes the embroidery frame move to right and left directions against the front of the embroidery machine
Y
Y DATA
The data that makes the embroidery frame move front/rear direction (Y direction) by the Y-axis drive system
Y-AXIS DRIVE SYSTEM
The drive system that makes the embroidery frame move to front and rear directions against the front of the embroidery machine
JZ07