TAJIMA TCMX 601, Руководство пользователя

Страница: 111 / 130

13-4
Troubleshooting
2.
Usual stop factor
Stop by the code numbers (100-series) described below is not caused by occurrence of error.
B01
Format error of the floppy disk
Format the floppy disk.
Replace with a new formatted floppy disk.
Abnormality occurred in reading/writing.
Copy other designs to a new floppy disk and dispose of the
old floppy disk.
B03 Write protect window of the floppy disk is open. Close the write protect window.
B04 A floppy disk is not inserted. Insert the floppy disk.
BC1
Selected design is not found on the floppy disk.
Select other design.
No design is registered in the floppy disk.
BC5 Remaining capacity of the floppy disk is not enough.
Replace with floppy disk that has enough remaining
capacity.
C01 The FDD does not work.
Check the FDD connector. If there is no problem with the
connection, replace the FDD unit.
No. Stop Factor Corrective Action
1B1 Stop due to a frame stepping code.
In this case, it is not stop by abnormality.
Perform “Start operation” or “Frame back/forward
operation”, or press any operation key (excluding manual
frame travel key) to continue operation of the machine.
1B2 Stop due to a stop code.
1B3 Stop due to stop code 1.
1B4 Stop due to thread trimming code.
1B6 Stop by offset code at automatic color change
1C1
The machine was stopped at frame stepping. Start the machine.
The machine was stopped during trace.
Press the reset key ( ) to reset the display.
1D1
Stop at the start of all-head embroidery due to the stop
setting.
Start the machine and continue embroidery.
1D2 Stop by preset halt (except lubrication)
Press the reset key ( ) to reset the display.
OIL Preset halt (lubrication)
Perform lubrication to the necessary spots and press the
reset key (
) to reset the display.
JZ07