TAJIMA TCMX 601, Руководство пользователя

Страница: 109 / 130

13-2
Troubleshooting
1.
Coping with error code
There are two main machine stop factors: one is stop by occurrence of error and another is stop by normal stop factor. How to
cope with errors when an error code of 2** series or 3** series occurred is explained here.
of 300 seriesWhen code number is displayed, contact the distributor.
NO. Stop Factor Corrective Action
211
The fixed position signal (main shaft Z signal) is not
detected. Return the main shaft to the fixed position. Check encoder
signal.
221
(*)
The embroidery frame has moved to the frame travel limit
position.
(Left direction).
Move the frame manually so that embroidery can be
performed within the set range.
* Only the model that has limit switch at drive system
222
(*)
The embroidery frame has moved to the frame travel limit
position.
(Right direction).
223
(*)
The embroidery frame has moved to the frame travel limit
position.
(Front direction).
224
(*)
The embroidery frame has moved to the frame travel limit
position.
(Rear direction).
225 The frame moved to the limit position during tracing.
Press the reset key ( ).
Check the current frame position.
251
(*)
Lubrication pump oil is insufficient.
Supply oil to the tank.
* Only the model that is equipped with automatic
lubrication system
255
Operation of frame forward or manual frame travel was
performed at other needle height position than H (retracting
position) of Z-axis at CM head.
Set needle height to H.
281
The target needle position is not detected even after 15
seconds from start of color change at FM head.
Return the needle position so that it becomes the correct
display. Adjust or replace the potentiometer (needle
position sensor).
291
The machine detected thread breakage. Check the thread.
Tension base card is faulty. Replace the tension base card.
293
The machine has detected under thread breakage. Check the under thread.
2B1
No response was given for five seconds at data input by
LAN
(No LAN connection).
Check connection of the device.
2B3
Data exists in an end code.
Correct the design data.
2B4
Function code error (The third character has no stitch
code.)
2B5
Sequin data error
2B7 Data is not set. Set data.
2BA
Memory capacity over Delete unnecessary designs registered in memory.
2BB
Available range to perform frame back was exceeded. Do not perform frame back any more.
Intention of frame back was made without effectiveness of
frame back function when CM head was selected.
Make frame back function effective (p.10-4).
2BC
No design is registered in the memory. Register designs in the memory.
Attempt was made to perform memory deletion of design
in the middle of embroidery.
To perform memory delete of design in process of
embroidery, perform data input of other data or perform
data input of the same design again.
Attempt was made to perform data edit (cleanup) in
process of embroidery. Do not perform data edit (cleanup) in process of
embroidery.
JZ07