SystemAir menerga TX, Инструкция по сборке

Страница: 37 / 52

The sticker (Fig. 28) marks the connection for the output of the
pool water condenser.
1.
When connecting the pipes, pay attention to
the labelling of the terminal (counterflow prin-
ciple).
To connect the pool water condenser, PVC
pipes must be used.
Note the description in relation to a flange
connection.
Adhere the PVC pipeline (Fig. 29/2) to the connection pipe
(Fig. 29/1).
2. Assemble shut-off device.
3. Assemble draining equipment.
4. Flush the water circuits with water before filling the water
circuit.
5. Fill the water circuit according to the technical data sheet of
the respective heat transfer media. See the technical data in
the
Ä
“ Operating manual ” .
6. Check the connections and the heat exchanger in the device
for leaks.
4.6 Connecting the building heat pump
Personnel: n Technicians for sanitary, heating and
air conditioning engineering systems
Protective equip-
ment:
n Safety shoes
n
Safety gloves
n Ear protection
n Occupational safety clothing (Personal
Protection Equipment - PPE)
The positions of the connections for the building heat pump of the
device are shown on the device drawing. The device drawing is
fixed to the outside of the transport units of the device and can also
be found in the operating manual; see example
Ä
Chapter 2.1.1
‘Type of packaging’ on page 13 .
Fig. 28: Pool water condenser Out
Fig. 29: Connecting the pool water
condenser
Connecting the building heat pump
25.08.2022 Device type: Menerga TX - ThermoCond 37