3.
Lay ropes or belts in the upper part of the transport section
on the rope spreaders (Fig. 10/1) and keep them apart with
the rope spreaders. In doing so, ensure that the ropes or
belts have no direct contact with the device.
WARNING!
Risk of injury due to falling or toppling trans-
port sections!
Falling or toppling transport sections can cause
serious injuries.
4.
Make sure that the transport section with a non centralised
centre of gravity cannot tip over.
5.
Align the rope spreaders (Fig. 10/1) to the centre of gravity
for a symmetrical load distribution before transporting.
6.
Lift the transport section slowly and start with lifting.
2.3 Storing transport sections
The device must be stored under the following conditions:
n
The ground must be even and horizontal.
n
Transport sections may not be stacked.
n
The device must be protected against ingress of dust and other
contaminants.
n
The storage environment for the device must be dry.
n
Penetration of moisture and condensation and high levels of air
humidity must be prevented.
n
The devices must be protected from UV light while in storage.
n
The fans and pumps must be rotated every three months when
stored for longer periods.
n
If moisture, dust or dirt enters into the device during storage,
then the device must be cleaned and disinfected before com-
missioning.
n
Minimum storage temperature
³
+5 °C
n
Maximum temperature variation 20°C/h
n
Maximum storage temperature
£
+45 °C
n
Air humidity
<
55 % (non-condensing)
Storing transport sections
25.08.2022
Device type: Menerga TX - ThermoCond
23