SystemAir AquaScop HT V2, Руководство по установке и обслуживанию

Страница: 47 / 84

English
45 Aqu@Scop HT V2
1. Check the proper operation of the high pressure protection devices.
24.1.5. ELECTRICAL EQUIPMENT
1. Check that the main power supply cable is not damaged or altered in such a way as to affect the
insulation.
2. Check that the interconnecting cables between the two units are not damaged or altered, and that
they are correctly connected.
3. Check the tightness of the screw terminals.
4. Check the general tightness of all cable connections.
5. Perform a visual check of the condition of the contacts.
6. Inspect the relay contact surfaces and the contractors and replace them if necessary.
7. Check nominal current draw and the condition of the fuses.
8. Clean the control box with compressed air to remove any build-ups of dust or dirt.
9. Check the earth grounding connection.
Les interventions dans les boitiers électriques sont réalisées pars des techniciens habilités.
1. Check that the hydraulic circuit is filled correctly and that the fluid circulates freely without any sign
of leaks or air bubbles.
2. Inspect filter cleanliness.
3. Check water pressure and flow.
24.1.6. PROTECTION DEVICES
24.1.7. HYDRAULIC CIRCUIT
CAUTION
BEFORE CARRYING OUT ANY OPERATION ON THE EQUIPMENT, CHECK
THAT THE ELECTRICAL POWER SUPPLY IS SWITCHED OFF AND THAT IT
CANNOT BE SWITCHED ON INADVERTENTLY.
IT IS RECOMMENDED THAT THE DISCONNECT SWITCH BE PADLOCKED