SystemAir AquaScop HT V2, Руководство по установке и обслуживанию

Страница: 22 / 84

English
20 Aqu@Scop HT V2
You must check water tightness and the cleanliness of the installation before connecting the Aqu@ Scop HT .
For the Aqu@ Scop HT 's WATER INLET and OUTLET connections, you must install manual stop cocks with
the same diameter as the main pipe work. This will enable maintenance work to be carried out on the
Aqu@ Scop HT without having to bleed the entire system.
A link valve with pressure tap kit is available.
The Aqu@ Scop HT must be protected by a water filter. When connecting this device to the Aqu@ Scop HT ,
take care to keep the water filter sieve pointing downwards. A sludge trap should be fitted in the event of
high sludge build-ups.
WARNING!
Take care not to damage the hydraulic pipe links by applying too much tightening pressure. Use a second
wrench to compensate for the tightening torque.
You should always use a counter-wrench for
tightening valves.
To guarantee proper energy efficiency and compliance with current standards, water pipes passing through
uninhabited zones should be properly lagged to retain heat.
To achieve correct insulation with conductivity of 0.04 W/mK, lag the pipes with insulating material with a
radial thickness between 25mm and 30 mm.
THE MANUFACTURER'S WARRANTY IS VOID IF THE FILTER SUPPLIED WITH THE AQU@ SCOP HT IS
NOT INSTALLED TO PROTECT THE APPLIANCE
AN EXPANSION TANK ADAPTED TO THE VOLUME OF WATER IN THE INSTALLATION MUST BE
INSTALLED.
It is important to ensure that the mains water supply pressure is sufficient to fill the installation.
12.4. CONNECTION TO THE CENTRAL HEATING LOOP
12.5. HEAT INSULATION