SystemAir AquaScop HT V2, Руководство по установке и обслуживанию

Страница: 7 / 84

English
5 Aqu@Scop HT V2
2. INSPECTION AND STORAGE
THE WARRANTY SHALL BE NULL AND VOID IN THE EVENT
OF NON-COMPLIANCE WITH ANY OF THE ABOVE CONDITIONS.
This range of air/water Aqu@ Scop HT (High Temperature) appliances offers the special feature of producing
hot water at 65° C at outdoor temperatures between 0° C and -20° C, while guaranteeing a high COP.
Between 0°C and +42°C, the temperature of the hot water produced varies between 65°C and 55°C for the
Heating mode and is maintained at 60°C for the Domestic Hot Water (DHW) mode.
Consequently, this
Aqu@ Scop HT system is ideally suited to replace a traditional hot water boiler in producing
DHW without alterations to the rest of the system.
This technology uses two-stage compressors connected to a patented refrigeration circuit.
This technology ensures remarkably accurate "capacity supplied/heating needs" matching due to its ability
to run each compressor independently. Depending on the demand for heating capacity and the operating
temperature of heat emitters (i.e. radiators, etc.) the Aqu@ Scop HT regulator selects either the small or
large compressor to operate on its own or in a two-stage mode.
3. WARRANTY
4. CONTENTS OF PACKAGE
5. PRODUCT PRESENTATION
At the time of receiving the equipment carefully cross check all the elements against the shipping documents
in order to ensure that all the crates and boxes have been received. Inspect all the units for any visible or
hidden damage.
In the event of shipping damage, write precise details of the damage on the shipper’s delivery note and
send immediately a registered letter to the shipper within 48 hours, clearly stating the damage caused.
Forward a copy of this letter to the manufacturer or his representative.
Never store or transport the unit upside down. It must be stored indoors, completely protected from
rain, snow etc. The unit must not be damaged by changes in the weather (high and low temperatures).
Excessively high temperatures (above 60 °C) can harm certain plastic materials and cause permanent
damage. Moreover, the performance of certain electrical or electronic components can be impaired.
The units are delivered fully assembled and tested.
Any modification to the units without the manufacturer’s prior approval, shall automatically render the
warranty null and void.
The following conditions must be respected in order to maintain the validity of the warranty:
²
Commissioning shall be performed by specialised technicians from technical services approved by
the manufacturer.
²
Maintenance shall be performed by technicians trained for this purpose.
²
Only Original Equipment spare parts shall be used.
²
All the operations listed in the present manual shall be performed within the required time limits.
1 HEAT Pump Aqu@ Scop HT
1 Documentation pouch
1 Water filter kit
1 stop cock
4 Anti-vibration pads