12
DePuy Synthes
Air Power Line II Instructions for Use
Air Reamer/Drill II
Inserting the tools in the attachments
(on page 9)
Attaching cutting tools
Pull the unlocking sleeve on the attachment backwards (for-
wards for the DHS/DCS Quick Coupling, 530.760) and com-
pletely insert the tool (e.g. drill bit) by lightly turning it.
Once the tool is completely locked in place, release the un-
locking sleeve. Turn slightly to ensure that the tool is properly
locked into the coupling.
For the AO/ASIF Quick Coupling (530.750/530.780) the tool
can be inserted without moving the unlocking sleeve
(“click-in”).
Removing cutting tools
Pull the unlocking sleeve on the attachment backwards
(forwards for the DHS/DCS Quick Coupling, 530.760) and
remove the tool.
Caution:
Properly operating tools are essential to the success
of an operation. For this reason, used tools must be checked
for wear and/or damage after each use and should be re-
placed if necessary.
