40
DePuy Synthes
Air Power Line II Instructions for Use
Troubleshooting
Problem
Possible causes
Solution
Power tools do not enough power.
Operating pressure is too low.
Set operating pressure on pressure
regulator to 6–7 bar overpressure.
Microfilter is blocked.
Exchange microfilter in the central air
supply.
Air inlet is blocked.
Remove particles from the air inlet
with tweezers.
Do not use sharp objects for this.
Hose is too long.
Check that the entire length of the
hose does not exceed 8 m.
Hose coupling is defective.
Check wall and power tool hose
couplings for leaks.
Central air system is blocked.
Have someone check the central air
system.
Power tool continues to operate
after releasing the trigger.
The trigger is blocked by deposits
of blood, etc.
Press trigger several times; clean and
oil according to instructions. Use only
Synthes Special Oil (Oil Dispenser
519.970).
Trigger is blocked.
Safety system is activated.
Unlock the power tool by turning and
pushing the trigger according to the
markings on the power tool.
Air Reamer/Drill does not start.
Compressed air motor is blocked from
not operating for a long time.
Lock the power tool. Rotate the un-
locking sleeve by hand without
pressing the trigger. Release the lock
and run the machine.
