SYMEO LPR-1DHP-200 Series, Продуктовая документация

Страница: 49 / 72

SYMEO Local Positioning Radar System
Product Family LPR
®
-1DHP-200 – Product Documentation
Device Setup via the Web User Interface
Copyright © Symeo GmbH 2018
DOC.EDO.000341.WORK.EN_LPR-1DHP-200_Product-Documentation.docx
Page 48 of 71
Measurement Details for Diversity Radar Mode
For diversity radar mode, you must enable the “ Diversity mode ” setting under the Settings ->
Measurement details. The following settings will additionally appear:
 Diversity partner IP address
o
In diversity mode the unit will connect to the diversity partner at the specified IP
address.
 Diversity partner sync channel
o
The sync channel of the diversity partner unit must also be specified. It is used
internally to verify data from the correct partner unit is received.
Device - Settings – Modem
In this menu, the following settings are available:
 PPP Point to Point protocol connection
 APN address
 APN username
 APN password
Device - Settings – Network Routes
In this menu, you can adapt the network routes.
 Click the “+ add route ” button.
The dialog box “ add route ” will appear.

Press the „
add route”
button.
Device - Settings – Relay
In this menu, the following setting are available:
 Relay data output
o
Relay switch commands can be used to control relays at other LPR
®
units, e.g. at
LPR
®
-1D24 devices
If the “ Relay data output ” is enabled, the following settings will additionally appear:
 Relay destination address
o
LPR
®
-B address of destination device where the relays are switched (hex value)
 Zone 1 distance
o
Relays assigned to zone 1 will open when measured distance is below this value
 Zone 2 distance
o
Relays assigned to zone 2 will open when measured distance is below this value
The virtual relays 1-4 can be assigned to switch according to system health, Zone 1 state or
Zone 2 state.