Swissvoice Eurit 535, Руководство пользователя, Страница: 83 / 102

203245631en_ba_b0
79
Operating the answering machine by remote access
Access without VIP number
With the answering machine on
1. Dial the multiple subscriber number
(MSN).
2. Temporarily switch the telephone to
tone dialling (DTMF), if not already
set.
The outgoing message (greeting
message) is now played back.
3. During the outgoing message enter
your personal remote access PIN.
The message is now interrupted.
The ready beep sounds.
4. You can now operate the
answering machine by pressing the
numeric keys.
With the answering machine off
1. Dial the multiple subscriber number
(MSN).
2. After 10 to 12 rings the answering
machine switches itself on (warning
beep) for 8 seconds without
playing an outgoing message.
3. Enter your remote access PIN.
The ready beep sounds.
4. You can now operate the
answering machine by pressing the
numeric keys.
PIN alarm
If you enter the remote access PIN
incorrectly, an error tone sounds. You will
then need to key in your remote access PIN
once again. Remote access is
always
protected, i.e. if you enter the remote access
PIN incorrectly three times in succession,
your telephone will automatically
disconnect the line. The PIN alarm is then
activated (indicated by rapid flashing of the
red light 2).
It is now impossible to gain remote access
to your answering machine until the PIN
alarm has been reset by pressing the On/
Off key at the base station.
Note:
If the red light 2 continues to flash rapidly,
the answering machine is full (delete at least
one message).
Switching the answering
machine on/off (for each MSN)
Press
⁄
.
The answering machine of the
respective MSN is now on and the
outgoing message is played.
Press
⁄
.
The answering machine of the
respective MSN is now off and an
acknowledgement beep sounds.
Note:
If no outgoing message (greeting message)
is played, the answering machine has been
unable to switch itself on because the
memory is full (delete at least one message).