A-96.250.211 / 171121
AMI Sodium P
Instrument Setup
51
The tubes are already installed into the tube holder [D] and the
EPDM seal [E] seats on the bottom of the tube holder. To install the
DIPA bottle proceed as follows:
1
Put the DIPA bottle [G] into the bottle holder [H].
2
Put the tube holder onto the DIPA bottle.
3
Screw the screw cover [A] onto the DIPA bottle and tighten it
firmly.
4
Screw the tube fitting of tube 1 [B] into the tube holder [D], so that
it is connected to the air inlet tube.
5
Screw the tube fitting of tube 2 [C] into the tube holder [D], so that
it is connected to the DIPA vapor outlet.
4.2. Installing the Regeneration Solution Bottle
If the automatic regeneration option is installed, screw a bottle of
SWAN regeneration solution to the holder and swing it upwards.
A
B
Bottle with Swan regeneration
solution
Bottle holder
A
B
