Suzuki Wagon R Plus RB310, Руководство по обслуживанию

Страница: 164 / 846

PARKING AND REAR BRAKE 5C-1
5C
SECTION 5C
PARKING AND REAR BRAKE
CONTENTS
On-Vehicle Service..........................................5C-2
Parking Brake Cable Component Location ...5C-4
Brake Drum (for 2WD Model)........................5C-5
Brake Drum Removal and Installation
(for 4WD Model)............................................5C-7
Brake Back Plate (for 2WD Model) ...............5C-9
Brake Back Plate (for 4WD Model) .............5C-11
Tightening Torque Specifications...............5C-11
Required Service Material ............................5C-12
Special Tools.................................................5C-12
WARNING:
For vehicles equipped with Supplemental Restraint (Air Bag) System:
• Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to “Air Bag System Components and Wiring Location View” under
“General Description” in air bag system section in order to confirm whether you are performing ser-
vice on or near the air bag system components or wiring. Please observe all WARNINGS and “Ser-
vice Precautions” under “On-Vehicle Service” in air bag system section before performing service
on or around the air bag system components or wiring. Failure to follow WARNINGS could result in
unintentional activation of the system or could render the system inoperative. Either of these two
conditions may result in severe injury.
• Technical service work must be started at least 90 seconds after the ignition switch is turned to the
“LOCK” position and the negative cable is disconnected from the battery. Otherwise, the system
may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
• Do not removal all of the wheel bolts at once, because all the wheels of this vehicle are mounted by
the wheel bolts.
Leave a bolt at least not to drop the wheel.
Support the wheel and/or tire and then remove the bolt(s) left with the wheel.
NOTE:
• All brake fasteners are important attaching parts in that they could affect the performance of vital
parts and systems, and/or could result in major repair expense. They must be replaced with one of
same part number or with an equivalent part if replacement becomes necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified
during reassembly to assure proper retention of all parts. There is to be no welding as it may result
in extensive damage and weakening of the metal.
• For descriptions (items) not found in this section, refer to the same section of the Service Manual
mentioned in FOREWORD of this manual.