Suzuki Wagon R Plus RB310, Руководство по обслуживанию

Страница: 114 / 846

REAR SUSPENSION 3E-23
15) Install rear axle shaft (right & left) to rear axle housing.
16) Tighten brake back plate bolts to specified torque.
Tightening torque
Brake back plate bolt (a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
17) Connect brake pipes (3) to wheel cylinders (1) (right & left)
and tighten brake pipe flare nuts (2) to specified torque.
Tightening torque
Brake pipe flare nut (b): 16 N·m (1.6 kg-m, 11.5 lb-ft)
18) Apply water tight sealant where brake back plate (1) and
parking brake cable contact.
Connect parking brake cable (2) to brake back plate (right &
left) and secure it with clip (3).
“A”: Sealant 99000-31090
19) Install brake shoes (right & left) referring to “Brake Shoe” in
Section 5C.
20) Install brake drums (1) (right & left) after making sure that
inside of brake drum and brake shoes are free from dirt and
oil. Then tighten brake drum screw (2).
21) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, refer to Section 5.)
22) Refill differential gear housing with new specified gear oil.
Refer to Section 7F.
23) Install wheels and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt (f): 95 N·m (9.5 kg-m, 69.0 lb-ft)
24) Upon completion of all jobs, pull parking brake lever with
about 200 N (20 kg, 44 lbs) load three to five times so as to
obtain proper drum-to-shoe clearance.
Adjust parking brake cable referring to “Parking Brake” in
Section 5.
25) Lower hoist.
NOTE:
Check to ensure that clip is in good condition before
installing it. If deformed or broken, replace.
A: Forward