Suzuki Wagon R Plus RB310, Руководство по обслуживанию

Страница: 628 / 846

AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-59
Troubleshooting
Step Action Yes No
1 Was “Automatic Transaxle Diagnostic Flow
Table” performed? Go to Step 2. Go to “Automatic Tran-
saxle Diagnostic Flow
Table” in this section.
2 Check Transmission Fluid Temperature Circuit
for Open.
1) Turn ignition switch OFF.
2) Disconnect TCM connectors from TCM.
3) Check for proper connection to transmission
fluid temperature sensor at terminals E13-
11 and E13-12.
4) If OK, check continuity between terminals
E13-11 and E13-12 of disconnected har-
ness side TCM connector.
Is continuity indicated?
Go to Step 3. “BLU/RED” or “GRN/
RED” circuit open.
3 Check Transmission Fluid Temperature Circuit
for IG Short.
1) Cool down A/T fluid temperature under
ambient temperature.
2) Connect TCM connectors to TCM with igni-
tion switch OFF.
3) Turn ignition switch ON.
4) Measure voltage between terminal E13-11
of TCM connector and ground.
Is it 4.6 V or more?
“GRN” circuit shorted to
power circuit.
If circuit is OK, go to Step
4. Intermittent trouble or
faulty TCM.
Check for intermittent
referring to “Intermittent
and Poor Connection” in
Section 0A.
If OK, substitute a known-
good TCM and recheck.
4 Inspect Transmission Fluid Temperature Sen-
sor.
Inspect transmission temperature sensor refer-
ring to “Transmission Fluid Temperature Sen-
sor” in this section.
Is result satisfactory? Intermittent trouble or
faulty TCM.
Check for intermittent
referring to “Intermittent
and Poor Connection” in
Section 0A.
If OK, substitute a known-
good TCM and recheck. Replace transmission
fluid temperature sensor.