Suzuki Wagon R Plus RB310, Руководство по обслуживанию

Страница: 550 / 846

MANUAL TRANSAXLE (M13 ENGINE) 7A2-27
7) Clean mating surfaces of both right and left cases, apply
sealant to right case (2) as shown in figure by such amount
that its section is 1.5mm (0.059 in.) in diameter then mate it
with left case (1).
“B”: Sealant 99000-31260
8) Tighten case bolts (3) from left case side to specified torque.
Tightening torque
Transaxle case bolt (b): 19 N·m (1.9 kg-m, 14.0 lb-ft)
9) Install reverse shaft bolt (4) to which thread lock cement
have been applied with aluminum washer and tighten it.
“A”: Thread lock cement 99000-32110
Tightening torque
Reverse shaft bolt (c): 23 N·m (2.3 kg-m, 17.0 lb-ft)
10) Install another case bolts from clutch housing side and
tighten them to specification.
Tightening torque
Transaxle case bolt: 19 N·m (1.9 kg-m, 14.0 lb-ft)
11) Install new snap ring (1) using special tool.
Special tool
(A): 09900-06107
12) Check locating spring for deterioration and replace with new
one as necessary.
Locating spring free length
For Low speed (3) and 5th & reverse (6)
Standard: 26.1 mm (1.028 in.)
Service Limit: 25.0 mm (0.984 in.)
For High speed (5)
Standard: 40.1 mm (1.579 in.)
Service Limit: 39.0 mm (1.535 in.)
13) Install steel balls (4) and locating springs (4, 5 and 6) for
respective gear shift shaft and tighten bolts (1) to which seal-
ant have been applied to its thread part.
“A”: Sealant 99000-31260
Tightening torque
Gear shift locating bolt (d): 13 N·m (1.3 kg-m, 9.5 lb-ft)
2. Input shaft
3. Input shaft left bearing
1
(A)
2
3
2. Washer