9
THROTTLE
Insert the boss of the throttle upper housing into the
hole on the handlebars.
Tighten the throttle assembly with two screws.
"
A: Boss
B: Hole
C: 5 × 50 mm screw
D: 5 × 30 mm screw
FRONT BRAKE MASTER CYLINDER
Install the front brake master cylinder onto the han-
dlebars. Align the dot mark on the handlebars with
the master cylinder-to-holder fitting surface. Tighten
the master cylinder mounting bolts to the specified
torque.
!
!
!
!
Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m)
A: Master cylinder
B: Holder
C: Flange bolt
D: Flange bolt
E: Dot mark
A: Bolt
B: Holder
C: Master cylinder
D: Handlebars
Check to ensure that the throttle operates
freely and closes automatically.
NOTE:
To install the holder correctly, first tighten the
bolt
C
C
C
C
of the upper side with specified torque
and then tighten the bolt
D
D
D
D
of the lower side.
NOTE:
Install the holder in position according to the
mark “UP”.
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
