7
FRONT/AVANT/VORNE
Install the handlebars assembly using the two
clamps, four bolts and washers.
A: Clamp
B: 8 × 40 mm flange bolt
C: Burring washer OD:13.0 mm ID:8.5 mm
D: Punch mark
E: Dot mark
Tighten the handlebar clamp bolts to the specified
torque.
!
!
!
!
Handlebar clamp bolt: 23 N·m (2.3 kgf-m)
A: 8 × 40 mm flange bolt
B: 8 × 40 mm flange bolt
C: Punch mark
D: Dot mark
"
A: Front brake hose
B: Throttle cable
C: Right switch wiring harness
D: Clutch cable
E: Left switch wiring harness
NOTE:
Install the burring washer in the direction as
shown in the illustration. The punch mark on
the clamps shows front side. Align the dot
mark on the handlebars with the mating sur-
face of the front side of left clamp.
NOTE:
To install the handlebars correctly, first tighten
the bolt
A
A
A
A
of the front side with specified
torque and then tighten the bolt
B
B
B
B
of the rear
side.
Make sure that the clamp has no clearance at
the front side as shown in the illustration.
The line drawings on page 50 and 51 show the
proper routing of the control cables, hose and
wirings. Refer to them in addition to following
the instructions carefully.
