NVR Software - SeeTec Surveillance
74
Video settings (multi-streaming disabled)
1. MPEG-4 / H.264 streaming only (configure the audio settings in the
MPEG-
4 / H.264 audio
menu):
Activate
Audio
, if the camera audio stream is to be transferred and
recorded.
If you want a user in
Surveillance Mode
to listen to the audio stream, he must be
assigned the corresponding right in
Authorization Management
.
2. Select the desired
Streaming mode
(
Motion JPEG
,
MPEG-4
or
H.264
)
and a
Transmission mode
.
The transfer modes depend on the camera type and the differences are as follows:
Motion JPEG:
HTTP Server Push: Communication between the SeeTec server and the
camera and the image transfer from the camera to the SeeTec server occurs
via port 80 (TCP) or HTTPS encrypted (port 443, TCP). The ports may be
changed.
MPEG-4/H.264:
RTP over Unicast (default)
: Communication between the SeeTec server
and the camera occurs via TCP port 554 (= RTSP port). The image transfer
from the camera to the SeeTec server occurs via a negotiated UDP port.
RTP over Multicast: Communication between the SeeTec server and the
camera occurs via TCP port 554 (= RTSP port). The image transfer occurs
via a multicast address that is communicated by the camera. RTP over
Multicast should only be used if third party systems and the SeeTec server
access the camera at the same time.
RTP over RTSP over HTTP / RTP over HTTP / TTS over HTTP: Communication
and image transfer occurs via an HTTP tunnel (port 80 TCP). This setting is
recommended in case of a poor network connection between the SeeTec
server and the camera. The drawbacks of this transfer method are possible
latency times because faulty data needs to be transferred repeatedly.
