NVR Software - SeeTec Surveillance
129
NAT list
To access SeeTec 5 via the internet without using a VPN tunnel, you first need to
enable the port forwarding feature on your router and/or your firewall. The default
ports required for this are 60000 – 60008 (TCP).
General
Address translation
1. Enter the internal IP address of the
SeeTec
server in the
Internal
computer name
field as well as the respective port in the Internal port
field.
2. In the
Public computer name
and
Public port
fields, enter the respective
IP address and port you set for port forwarding, e.g.
Internal computer name
Internal port
192.168.0.1
60000
Public computer name
Public port
111.111.111.111
64000
3. Then, click on
Add new entry
.
4. Repeat this step until you have integrated all ports.
5. To delete an entry, select it and click on
Remove selected entry
.
If encrypted communication is enabled (see chapter
Installation
(page 27)), you
need to enable port forwarding for port 60011 and 60012, as well.
Important
When logging in via NAT, the
Use NAT translation
option must be
enabled during server selection.
When logging in without NAT, this option must be disabled before
login.
When you want to communicate to a distributed installation via NAT,
then you must also create inputs for ports used (60006 and 60008)
on the distributed servers.
6. To delete an entry, select it and click on
Remove selected entry
.
EBÜS interface
In the
EBÜS interface
you can configure the interface between SeeTec and EBÜS
(consistent image transmission system, producer: Accellence Technologies GmbH).
For further information, see the EBÜS interface manual.
