173
4.5.8 Every 1000 hours service.
Carry out EVERY 50 HOURS, EVERY 100
HOURS and EVERY 250 HOURS, EVERY 500
HOUR at the same time.
4.5.8.1 Replace swing redactor gear oil
(6.6L)
Stop the machine at level ground.
Stop auto-idle switch, run the engine unloaded
at low speed for 5 minutes.
【Important】
Stopping the engine improperly may
damage turbocharger.
Set start key to OFF position, stop the engine,
remove the key from starting lock, set safety
lock lever to LOCK position.
Note
After completing work, the gear oil
temperature might be very high, wait
for temperature to cool down.
Place a container under drain pipe to collect
oil.
Loosen drain plug to drain the oil, and then
tighten the plug.
Remove oil fill end cover, add specified gear
lubricate oil.
Remove dipstick of swing redactor, wipe off
oil with clean cloth, re-insert dipstick, then
pull out again, the mark of oil should be
between two scales.
If the oil level doesn’t reach mark L, add oil
through oil fill port, if the oil level exceeds
mark H, drain excessive engine oil and check
oil level again.
Содержание SWE150F
