170
4.5.6.4 Clean air filter cartridge
Stop the machine at level ground, lower
bucket to ground..
Shut auto-idle speed switch to run engine
unloaded at low speed for 5 minutes.
【Important】
Stopping the engine improperly may
damage turbocharger.
Set start key to OFF position, stop the engine,
remove the key from starting lock, set safety
lock lever to LOCK position.
Loosen clamp buckle (2) to remove air filter
front cover.
Remove outside filter (1), clap slightly by
hand, never hit with hard object.
Note
Minimize pressure of compressed air
(<0.2 MPa, 2kgf/cm
2
) , let go of
personnel around to avoid scattered
broken
pieces,
wear
personal
protective
articles
including
goggles and protective glassed.
Use compressed air to clean outside filter (1),
following the wrinkle direction to blow air
outward.
Clean up the inside filter.
Install outside filter (1), end cover, fasten
clamp buckle (2).
Start engine; run it unloaded at low speed.
Check filter clogging indicator on monitor. If
this indicator illuminates, shut engine
immediately and replace outside filter (1).
Replace internal filter (3) the moment outside
filter (3) is replaced.
4.5.6.5 Checking hose and piping leakage,
interference wear-out.
For detail, please refer to chapter 4.5.1.6.
Содержание SWE150F
