Sun Microsystems Netra ct, Руководство по установке

Страница: 126 / 174

108 Netra ct Server Installation Guide • September 2002
If you need to remove a wire from the DC input plug, insert the cage clamp
operating lever or a small screwdriver into the slot directly above the wire and press
down (
FIGURE 6-45
and
FIGURE 6-46
), then pull the wire from the DC input plug.
▼
To Install the Strain Relief Housings
1. Take the DC input plug and insert the bottom portion of the strain relief housing
into the notch on the DC input plug until it snaps into place.
Make sure the strain relief housing snaps into place on the DC input plug; you will
not be able to complete the assembly correctly if the strain relief housing is not
snapped into place.
FIGURE 6-48
Inserting the Bottom Portion of the Strain Relief Housing
2. Route the three wires coming from the DC power source through the opening at
the end of the bottom portion of the strain relief housing.