Suitmate Swimsuit Water Extractor, Инструкция по установке и обслуживанию

Страница: 55 / 72

April 13, 2009 115-V 20-Amp 60-Hz Self-Timed Unit
53
REMOVE AND REPLACE MOTOR SWITCH
The Motor Switch can be serviced from the bottom of the unit without removing the unit from the wall.
Do This FIRST
Make certain you have all the correct parts and fasteners necessary for correct installation. Parts used in this
process: (1) AEC1905 Motor Switch.
REMOVE MOTOR SWITCH
1) Turn off the main electrical power to the unit – place a lockout tag on the circuit breaker panel indicating that
the breaker is not to be turned on except by authorized personnel and disconnect the unit before doing any
work on the SUITMATE
®
unit. Simply turning off a switch is NOT enough.
2) Remove the Motor end cap by loosening the (2) captive screws and setting the end cap aside.
3) Remove the hex head screw holding the Motor Switch in place. Set it aside for reassembly.
Note: Carefully note the position and location of the old Motor Switch, as the new Motor Switch must be
installed in the same position and location as the old one. Refer to Page 52 for additional information.
REPLACE MOTOR SWITCH
1) Remove the wires, one at a time, from the Motor Switch. Put each wire in the matching position on the new
Motor Switch.
2) Replace the old Motor Switch with the newly connected Motor Switch. Position the Motor Switch in the
Motor and tighten the hex head screw previously removed.
3) Replace the previously removed Motor end cap.
4) Turn on the main electrical power to the unit and retest to assure proper operation. Refer to TESTING AND
OPERATION on Page 8.
WWW.RESTROOMDIRECT.COM 704•937•2673 129 Oakpark Dr., Unit A, Mooresville, NC 28115