Suitmate Swimsuit Water Extractor, Инструкция по установке и обслуживанию

Страница: 43 / 72

April 13, 2009 115-V 20-Amp 60-Hz Self-Timed Unit
41
REMOVE AND REPLACE SHOCK BUMPER RINGS
Do this FIRST
Make certain you have all the correct parts and fasteners necessary for correct installation. Re-use any
components that are not damaged, otherwise replace them. Parts used in this process: (3) AEC1223 Shock
Bumper Rings, (3) AEC1228 Washers, (3) AEC1206 S.S. Pop Rivets. Plus any components required to prop-
erly reinstall the Shock Mounts (Page 39), the Basket, Hub and Brake Disc Assembly (Page 31), the Drive Unit
Assembly (Page 27), and the Sub-Top and Top Assemblies (Page 19).
REMOVE SHOCK BUMPER RINGS
1) Remove SUITMATE
®
unit from the Wall Mount Bracket. See instructions beginning on Page 17.
2) Remove Top and Sub-Top Assemblies. See instructions beginning on Page 19.
3) Remove Drive Unit Assembly. See instructions beginning on Page 27.
4) Remove the (3) S.S. Nuts that secure the (3) Shock Mounts to the (3) Shock Bumper Rings.
5) Remove the Shock Mount from the Shock Bumper Ring.
Note: Examine the positions of the 3 Shock Bumper Rings. Two Bumper Rings should be parallel to each
other. The third should be perpendicular to the other two. See Bottom View of Drive Unit on Page 40
for details.
6) Remove the rivet that holds the Shock Bumper Ring to the Motor Mounting Plate.
a. Punch out center of the rivet with a small drift punch.
b. Drill out the rivet.
c. Chisel off the rivet head. Make sure the rivet is completely removed.
Note: Set aside the small washer that helps to secure the Shock Bumper Ring to the Motor Mounting
Plate. If the washers are deformed, they must be replaced.
REPLACE SHOCK BUMPER RINGS
1) Rivet the Shock Bumper Ring to the Motor Mounting Plate.
Note: Be certain to use the small washer (AEC1228) in riveting the Shock Bumper Ring to the Motor
Mounting Plate. Make certain the Shock Bumper Ring Assembly is properly aligned with the other two
Bumper Rings. Failure to do so will prevent proper reassembly of the SUITMATE
®
unit.
2) Apply clear Silicone sealer (available locally) on the rivet head located on top of the Motor Mounting Plate.
3) Reinstall the (3) Shock Mounts. See instructions beginning on page 39.
4) Reinstall Drive Unit Assembly. See instructions beginning on Page 27.
5) Reinstall Sub-Top and Top Assemblies. See instructions beginning on Page 19.
6) Reinstall the SUITMATE
®
unit to the Wall Mount Bracket. See instructions beginning on Page 18.
7) Retest the SUITMATE
®
unit for proper operation, refer to TESTING AND OPERATION on Page 8.
WWW.RESTROOMDIRECT.COM 704•937•2673 129 Oakpark Dr., Unit A, Mooresville, NC 28115