Suitmate Swimsuit Water Extractor, Инструкция по установке и обслуживанию

Страница: 31 / 72

April 13, 2009 115-V 20-Amp 60-Hz Self-Timed Unit
29
REMOVE / REPLACE BLACK PLASTIC LINER FROM CASE
Do this FIRST
Make certain you have all the correct parts and fasteners necessary for correct installation. Re-use any
components that are not damaged, otherwise replace them. Parts used in this process: (4) AEC1244 Foam
Strips, (1) DEC1213 Black Plastic Liner, (1) AEC1249 S.S. Hose Clamp, (1) AEC1248 Black Drain Hose,
and (1) AEC1243 Foam Strip. Plus any components required to properly reinstall the Drive Unit Assembly
(Page 27) and the Sub-Top and Top Assemblies (Page 19).
REMOVE LINER
1) Remove SUITMATE
®
unit from the Wall Mount Bracket. See instructions beginning on Page 17.
2) Remove Top and Sub-Top Assemblies. See instructions beginning on Page 19.
3) Remove Drive Unit Assembly. See instructions beginning on Page 27.
4) Place the SUITMATE
®
unit on its face to expose the bottom of the unit.
5) If the factory supplied drain hose was used, unscrew the hose clamp that holds the plastic drain tube to the
Liner drain hose outlet.
6) Remove the drain hose and set it aside for reassembly.
7) Place the SUITMATE
®
unit in an upright position.
8) From the top of the SUITMATE
®
unit, grasp the lip of the Black Plastic Liner and pull straight up. Be careful
not to damage the Liner. If the Liner is damaged, it must be replaced.
REPLACE LINER
1) Place the Liner into the case using care not to damage it.
2) If the factory supplied drain hose was used, reinstall it using the hose clamp removed in step 5 above.
3) Reinstall the Drive Unit. See instructions beginning on Page 27.
4) Reinstall the Sub-Top and Top Assemblies. See instruction beginning on Page 21.
5) Reinstall SUITMATE
®
unit to the Wall Mount Bracket. See instructions beginning on Page 18.
6) Retest the SUITMATE
®
unit proper operation, refer to TESTING AND OPERATION on Page 8.
WWW.RESTROOMDIRECT.COM 704•937•2673 129 Oakpark Dr., Unit A, Mooresville, NC 28115