Strata CIX 200, Руководство по программированию

Страница: 318 / 508

IP Telephone Programming
CIX IP Telephone Programming Guidelines
8-4
Strata CIX Programming Vol.1 12/09
CIX IP Telephone Programming Guidelines
Use the following guidelines to program your CIX IP Telephone.
Basic CIX IP Setup
1. Select System > Card Assignment (Program 100) to set the xIPU cards in the appropriate slots.
CIX100 slots 1~8; CIX670/CIX1200 Base slots 1~8; and CIX670/CIX1200 Expansion slots 1~6
Note If the CIX is initialized (Program 900-01) after the BIPU-M is installed, the CIX assigns the BIPU-M
to the appropriate card slots automatically.
2. Select IP Telephony > BIPU Configuration (Program 151) to set BIPU-M IP address (check with the
network administrator for IP address, subnet mask, etc.). The BIPU version number will be displayed
when the BIPU is operating and is connected on the same network as the Network eManager PC.
Note If the CIX is initialized (Program 900-01) after the BIPU-M is installed, the CIX assigns the BIPU-M
default parameters as shown in
Table 1-6 on page 1-6 .
3. Select Station > Station Assignments, Basic tab, to assign PDNs to IP telephones (BIPU equipment
numbers) if this was not done during CIX system initialization. The PDN Range wizard can also be used
to assign PDNs to the BIPU channels.
4. Select IP-Telephony > IPT Data (Program 250). Set field 05 Station Terminal Authentication Mode to
apply if the PDN assigned to a particular IP Telephone should be linked (reserved for) to that
telephone’s MAC address. Each telephone has a unique hard-coded MAC address. This prevents other
IP telephones from using the reserved PDN when an IP telephone is moved.
Note If IP telephone Authentication is applied/not applied in Program 250-05 it will override the IP
telephone Authentication setting in Program 150-02.
5. If multiple CIX systems with BIPU-Ms are connected to the IP network Select IP-Telephony > System IP
Data (Program 150), and set 09 IP CTX Identifier.
Enter a CIX Node identifier if more than one CIX Node is on the IP Network. This can be the same as
the Strata Net Network Node ID used for this system if it is in a CIX Strata Net Network - but the two IDs
are not related in software logic.
This ID must match the node number programmed in the IP telephone using 369Hold-2 , FB06.
6. Run all other CIX programs necessary to customize the features required for each IP telephone. All
programs used to program digital telephones also apply to IP telephones (Program 205 keystrips, 213
Add-on-Modules, Program 204 DKT Parameters, etc.).