Standard Horizon Quantum GX5000S, Руководство пользователя

Страница: 50 / 100

GX5000S Page 50
to communicate on and press the [ ENT
] key.
6. Press the [ ENT
] key again to transmit the
Group Call signal.
7. When the Group Call signal is sent, the LCD
will be as shown in the illustration at the right.
8. After the GROUP CALL is transmitted, all
the radios in the group will switch to the des-
ignated channel.
9. Listen to the channel to make sure it is not
busy, then key the microphone and call the
other vessels you desire to communicate
with.
Manual Calling
You may enter a Group MMSI number manually to contact without the Setting
up a Group call number.
1. Press the [ CALL
(
MENU
)] key. The “
DSC Call DSC Call DSC Call DSC Call DSC Call
Menu Menu
Menu Menu
Menu
” will appear.
2. Turn the CHANNEL selector knob to select
“
Group Group
Group Group Group
.” (To cancel, press the [ CLR
] key.)
3. Press the [ ENT
] key. The transceiver will beep,
and the “Group Directory” will appear.
4. Turn the CHANNEL selector knob to select
“
Manual Manual
Manual Manual
Manual
,” then press the [ ENT
] key.
5. Turn the CHANNEL selector knob to scroll through
numbers, 0-9. To enter the desired number and move
one space to the right press the [
ENT
] key. Repeat
this procedure until all nine space of the MMSI num-
ber which you want to contact are entered.
6. If a mistake was made entering in the MMSI
number repeat pressing the [ H/L
(
NAV
)] key un-
til the wrong number is selected, then move
the channel knob to correct the entry.
7. When finish the entering the MMSI number, press
and hold the [ ENT
] key.
8. Turn the CHANNEL selector knob to select
“
Manual Manual Manual Manual Manual
,” then press the [ ENT
] key.
9. Turn the CHANNEL selector knob to select the
operating channel you want to communicate
on and press the [
ENT
] key.