10
Information on programming
In order to use the door intercom
system, at least one door call must
be programmed in the In-Home bus.
Programming is described in detail
in the system manual In-Home bus:
Video.
In addition to the
basic functions
,
you can program additional func
-
tions using the
programming soft-
ware
BPS 650-… . For connecting
the PC to the
In-Home bus: Video
,
a programming interface
PRI 602-… USB and a ZBVG 650-…
plug-in card are required.
The Gateway can be integrated
into the In-Home bus in 2 ways:
Programming with the bus program-
ming software (recommended) or
manual programming (Teach-In).
Programming with Bus program-
ming software BPS 650-…
When integrating the Gateway in
the In-Home bus using bus program-
ming, a greater functional scope is
available at the Gateway (basic func-
tions and supplementary functions).
Manual programming, also called
“Teach-In”
When integrating the Gateway in
the In-Home bus using manual pro-
gramming, only individual functions
are available at the Gateway. When
carrying out manual programming,
you can assign only one bus address
to the Smart Gateway, to allow
either an IP user or an IP group to be
selectively called. If this is not ade-
quate, you must carry out program
-
ming using the bus programming
software. If you decide in favour
of manual programming, the steps
with bus programming software are
omitted.
Remarks on the Finder function
In the bus programming software
(BPS), the Finder function can be
used in order to determine the IP
address of the Gateway.
Using the Finder function, you can
locate all Gateways existing in the
network, provided these are located
in the same network as the commis-
sioning PC.
Important: A Gateway can only
locate the Finder function in the
network if the Gateway is in the
same subnet of your network (i.e.
the first three blocks of the local IP
address must be the same – e.g.
192.168.178.xxx).
If the Gateway is not located in the
same subnet, you will need to con-
nect your commissioning PC/laptop
directly to the Gateway to be able to
carry out the configuration.
Important:
The Gateway must be operated in
the local network using a static IP
address (not DHCP operation).
Preparation
