PolosSpin150i/200i
rev.: 1.0
Operating instruction
SPS-Europe B.V.
page
43
JH131115
End of cycle
When a recipe is active, touching
the “End of Cycle”
(12)
an
“E” like “End” will
appear on the status bar
(2)
near the number of current cycle.
The recipe will continue as programmed but will stop after the last step of actual
cycle and will not begin the next one.
When the “EOC” button is touched for a second time, the program will execute all
remaining cycles.
Select different step
Each recipe step is represented by a button on the step selection list
(5)
. When a
recipe is running, the button relative to actual step lights in green.
It is possible to execute a recipe starting from different step just selecting it while the
unit is in idle mode
While a recipe is running, the operator can move through the steps at any time by
clicking on them.
If the recipe has more than 5 steps, the two buttons below the list, page-forward and
page-backward, will be enabled to allow visualization of further steps.
When the steps are not named, they will be labelled as
“step 1”, “step 2”, and so on.
Log file
Touching log file button
(13)
will prompt a new window showing actual log file, listing
important status information.
In case of an occurring error, the relative button
(13)
will light with a warning
symbol:
.
Clicking on it, the user can access the log file to identify the reason of the alarm.
