PolosSpin150i/200i
rev.: 1.0
Operating instruction
SPS-Europe B.V.
page
18
JH131115
3.5 System restore after emergencies
DANGER!
Reactivating of the system after an emergency stop may only be done by qualified
persons. Prior to restarting, the system has to be checked for eventual hazards.
Prior to checking of risk area operate the main switch and disconnect the system
from mains power line and media supply except exhaust.
Wait until all hot parts have reached ambient temperature
.
DANGER!
In case of emergency while handling chemicals, please call immediately for a safety
expert or for a physician and act according to instructions of the data sheet of the
applied process chemical.
DANGER!
Disconnect all wires of power supply prior to opening of the system. In case work
has to be done while the system remains open (for adjustments, maintenance etc.)
it should only be done by qualified personnel, knowing all potentially dangerous
points and being able to prevent hazards by taking appropriate precautions.
Whenever it is likely that the system is no longer safe, make it inoperable and
secure it against any unauthorized or unintentional operation.
The system is likely to be unsafe if:
any damage is visible
it fails to perform according to specification
it has been subject to prolonged storage under unfavorable conditions
it has been subject to severe transport stress.
In these cases the safety state of the machine has to be checked by
SPS-
Europe B.V.
service personnel.
Maintenance and repair work required, but not listed in this manual, should only be
done by
SPS-Europe B.V.
service or by persons of equivalent qualification.
