Operator
’s Manual – Spider CROSS LINER
33 / 64
Make sure that the ramps have enough load capacity. The load capacity must correspond with the weight of the
mower listed on the production plate.
Do not allow any person to stand on or close to the ramps when loading.
Make sure that the transport vehicle is suitable for the size and weight of the mower. See also:
TRANSPORT ANCHORING POINTS
The mower must be properly secured for a safe transport. Use the points marked with the chain symbol to secure
the mower.
For fastening, thread the securing strap around the engine girder and hook the strap to the anchoring loop (see
Figure 10). Fasten both sides of the mower.
ATTENTION
Take extra care around the exhaust pipe before passing the clamping strap. If the engine is still warm, it
may cause burns to limbs or strap!
3.10 OPERATING CONDITIONS
Observe the following precautions. It will make it easier for you to start operating and prevent possible damage to
the mower.
The mower is designed to operate under atmospheric temperatures
between -20
° C and 46° C
.
BASIC MEASURES
•
Use lubricating oils with the correct viscosity. See also:
LIQUIDS, LUBRICANTS AND FILLING VOLUMES
•
Use hydraulic fluid with the correct viscosity. See also
: LIQUIDS, LUBRICANTS AND FILLING VOLUMES
•
Keep the battery fully charged.
•
Always fill the fuel tank at the end of the work shift. This will prevent condensation on the tank walls.
•
Protect the mower while it is out of service. Park the mower inside of a building or cover it with a tarpaulin.
Ensure the engine is cold when covering.
•
Check the air vents. Make sure that the air vents leading to and from the engine compartment are not blocked.
ENGINE GIRDER
NOSNÍK
MOTORU
SECURING
STRAP
UP
ÍNACÍ PÁS
Figure 10
– transport anchoring points
