Spectra Logic T-Series Spectra T200, Руководство пользователя

Страница: 20 / 110

Chapter 1 – Identifying Components and Preparing for Maintenance
20
Install the Cover
1. Lift the cover and align it so that the two nuts extending from the back of the cover
fit into the corresponding holes on either side of the chassis (Figure 1-5).
ƒ
If the cables to the drives and QIPs installed in the library are routed from the
top of the library, make sure that they fit into the cutout in the top of the cover.
ƒ
If the cables to the drives and QIPs installed in the library are routed from the
bottom of the library, make sure that they fit into the cutout in the bottom of the
cover.
Caution:
Make sure that cables are not pinched between the cover and
the chassis.
2.
Using your fingers or a #2 Phillips screwdriver, tighten the two screws to secure the
bottom of the cover to the chassis (see Figure 1-4 on page 19).
Figure 1-5 Align the cover alignment nuts (one on each side) with
the holes in the chassis.
Alignment
nut
Top cable cutout