Specialized LEVO SL COMP, Руководство пользователя

Страница: 8 / 193

6
ENGLISH
FRANÇAIS
DEUTSCH
ČESKY
HR
VA
TSKI
SLOVENŠČINA
WARNING! Many components on the LEVO SL, including, but not limited to the motor, battery
and cable guides, are proprietary to the LEVO SL. Only use originally supplied components and
hardware at all times. Use of other components or hardware will compromise the integrity and
strength of the assembly. LEVO SL specific components should only be used on the LEVO SL and
not on other bicycles, even if they fit. Failure to follow this warning could result in serious injury or
death.
WARNING! Never modify your frame or bicycle in any way. Do not sand, drill, file or remove parts
from your bicycle. Do not install incompatible components or hardware. Failure to follow this
warning may result in serious personal injury or death.
WARNING! Electrical components can be exposed when working on your bicycle. Do not touch
any part of the electrical system while under electric charge. Do not expose the connections of
the battery and frame to water. If any live components or the battery are damaged, stop riding
immediately and bring your bicycle to your Authorized Specialized Retailer.
5.1. SEATPOST
SEATPOST INSTALLATION - SEAT COLLAR
„
Ensure the seat collar is positioned so the slot
faces forward (Fig. 5.1).
„
Adjust the saddle height.
„
Verify the saddle height and position, adjust if
necessary.
„
Torque the seat collar to 55 in-lbf / 6.2 Nm.
TECH TIP: The fit between the seatpost and the seat tube must allow the seatpost to slide into
the seat tube smoothly and without twisting, but not so loosely that there’s excessive side-to-side
play/wiggle. Any fit and/or torque issues should be inspected by your Authorized Specialized
Retailer. If the seatpost does not fit properly or moves in the frame even though it is torqued to
spec, you should have it inspected by your Authorized Specialized Retailer.
SEATPOST MINIMUM INSERTION:
To prevent damage to the frame and/or seatpost, it
is important to have a minimum amount of seatpost
insertion in the seat tube. This minimum insertion
must meet the following requirements:
The seatpost must be inserted into the frame
deep enough so the minimum insertion/maximum
extension (min/max) mark on the seatpost is not
visible (Fig. 5.2 A).
The seatpost must also be inserted into the seat
tube deep enough to meet or exceed the 100 mm
minimum measured insertion depth (Fig. 5.2 B)
required by the frame.
If the seatpost and frame minimum insertion
requirements differ from each other, always use the
deeper minimum insertion. For example, if the frame
requires 100 mm, but the seatpost requires 90 mm,
then 100 mm is the minimum insertion required.
5.1
A
B
5.2