Southwestern Industries TRAK 2OP M11, Безопасность, Установка, Обслуживание, Сервис и Список Запасных Частей

Страница: 17 / 236

14
Southwestern Industries, Inc.
TRAK

2
OP
M11 Installation, Maintenance, Service, & Part List Manual
Figure 2.4.7a
2.4.8 Home switches
Each axis has a home switch which is used to home the mill. The machine must be homed each
time the control is powered on.
Warning
It is not recommended that the position of the home switches be changed. They are preset at
the factory and should require no additional adjustments. Should any major adjustments be
done, service codes 500, 505, and 520 may need to be performed.
2.4.9 Lubrication System
The automatic lubricating system is a centralized system. It is located on the left side of the
machine. While the system is automatic, it is recommended that after long idle periods, the
machine be manually lubricated by using service code 300. Cycle the lube pump two to three
times. The lubrication reservoir should be maintained on a daily basis, filling only with high
quality lubricating oil. See section 3.9
2.4.10 Coolant and Coolant Wash System
The coolant and coolant wash system uses 1 pump to provide coolant to the work and also to
wash chip away from the area where the ATC comes out. Wash areas can be controlled by the
flexible coolant lines found at the base of the enclosure.
The coolant tank holds approximately 15 gallons of coolant.
See drawing 27557 at the rear of the manual for the coolant system.
2.4.11 Pneumatic System
The machine requires a supply of compressed air between 85-100 psi with a recommended air
supply of ½” I.D, minimum is 3/8” ID . Air pressure to pneumatic components, the ATC slide
mechanism, and air purge (internal spindle) can be controlled individually by means of the
adjusting valves located at the back of the 2 OP mill. See drawing 27563-1 for an overview of
the pneumatic system.
CAUTION!
Always Observe Low Air Pressure and Low Oil Level Warnings