Southwestern Industries TRAK 2OP M11, Безопасность, Установка, Обслуживание, Сервис и Список Запасных Частей, Страница: 11 / 236

8
Southwestern Industries, Inc.
TRAK

2
OP
M11 Installation, Maintenance, Service, & Part List Manual
2.0 System Description
Read and understand this entire installation section before beginning the installation procedure.
2.1 Machine Specifications
Please see the drawing on the next page for a layout of the TRAK 2
OP
machine.
Overall Machine Dimensions
Width of machine 30.5”
Depth of machine 52”
Height of mill with head all the way up 101”
Minimum height to fit mill through doorway 92”
(Z cable carrier collapsed, resistor cover and resistors removed)
Machine Specifications
Table Dimensions
Table size 18” x 15”
Number of tee slots and pitch 4 @ 63 mm
Tee slot width 0.630” or 16 mm
Table maximum load 500 lbs.
Ball Lock ® hold down force 2250 lbs @ 35 in/lbs of
torque
Machine Weight ~2825 lbs
Machine Shipping Weight ~3175 lbs
Travel
X-axis 14”
Y-axis 18”
(12” of machining travel)
Z-axis 17”
Maximum distance from spindle nose table surface 20.25”
Minimum distance from spindle nose table surface 2.75”
Maximum swing clearance from spindle center to column 14”
Maximum Rapid speed X, Y & Z-axis, inches per minute 600
Spindle
Tool holder type BT30
Spindle nose diameter 2.2” or 56 mm
Maximum RPM 6000
Automatic Tool Carrier
Tool Capacity 8
Maximum tool diameter 2 or ~50 mm
Retention knob See section 3.4.4
Longest Tool that can be use in ATC – length measured from
bottom of drive dog flange on holder
6.75”
Air Requirements
Pressure 90 psi
Quality
CFM
SCFM
Air dried/filtered water
separator upstream of the
machine
2.5 @ 90 psi
18