Southwestern Industries TRAK 2OP M11, Безопасность, Установка, Обслуживание, Сервис и Список Запасных Частей

Страница: 118 / 236

115
Southwestern Industries, Inc.
TRAK

2
OP
M11 Installation, Maintenance, Service, & Part List Manual
c. Now use the up and down arrows to scroll to 19 and press Program/Data
d. Enter the offset found in service code 510 and press Program/Data
e. Press Mode button to return to frequency reading.
3. Lastly, go back to service code 510 and re-calibrate the spindle. Press the CAL RPM button and
following the instructions on the screen.
6.3 Computer Module Replacement
Caution!
Make sure you have a back up copy of the machines configuration file when replacing the computer.
Failure to do so will require you to reset all the important machine parameters such as ball lock locations,
tool change height, ATC locations, etc.
The following service codes
must be performed when a computer is replaced. Failure to do so will cause
many parameters to be incorrect and will lead to the machine crashing.
 Service Code 142 – Save the configuration file from old computer module to a USB device.
 Service Code 141 – Load the configuration file back into the new computer from a USB
device that contains all important machine parameters.
Refer to section 5.3 for a drawing of the computer module and cable connections.
1. If you do not have a copy of your configuration file and the computer module is still functional,
perform service code 142 and save your machines configuration file to a thumb drive. If you are not
able to run this service code, then contact Southwestern Industries. We should be able to email you
a backup copy of this file.
2. Turn power off to the control and machine.
Note – steps 1 and 7 can be avoided if you are able to reuse the compact flash card, which contains the
operating system and your machines configuration.
3. Remove all cables from the computer module.
4. Remove the 4 SHCS that hold the computer module in place.
5. Fasten the new computer module in place and connect all cables.
6. Turn power on to the machine.
7. Go to service code 141 to load in the saved configuration file.
6.4 Linear Guide Replacement
The linear guides that have come with the 2 OP should be trouble free for many years as long as they are
properly lubricated per the specifications stated in this manual. Should the time come when a linear
guide will need to be replaced, a machine tool builder will need to be hired to do this work. In order to
replace the linear guides, major castings will need to be removed. For example, if the Z linear guides
needed replacing, the head of the machine would need to be removed. All linear guide spare parts would
be purchased through Southwestern Industries and we would also organize finding a machine tool
rebuilder to do the work.
6.5 Ballscrew Replacement, X Axis
Please refer to assembly drawing 27520-1 at the back of this manual.
1. Remove the sheet metal and covers
a. Remove the side enclosure covers, left and right.