Sony VPD-LE100, Руководство по эксплуатации

Страница: 13 / 44

13
Location and Function of Controls
qa
CONTROL S IN/OUT jacks (stereo minijack)
Connect to the control S jacks of other Sony
equipment.
CONTROL S IN/PLUG IN POWER (DC 5 V
output) jack: Connects to the CONTROL S OUT
jack of the supplied Remote Commander when
using as a wired Remote Commander. In this case,
you do not need to install the batteries in the
Remote Commander, since the power is supplied
from this jack.
CONTROL S OUT jack: Outputs the control S
signal.
Note
When connecting the remote commander cable to the
CONTROL S IN jack, the remote control detectors
will not function.
qs TRIG (trigger output) jack (monaural minijack)
The signal is transmitted from this jack to the
connected equipment whether the projector is on or
off. (This is not a power source for external
equipment.) When the power is on, the TRIG jack
transmits approximately 12 V trigger signal to external
equipment connected to the projector. This signal is
useful when you connect a system integrator, etc., to
the projector; you can pull down an electric screen,
draw an electric curtain, or dim lights at the same time
as you turn on the projector power. (You cannot use
the trigger signal as a power source.)
This jack outputs 0 V DC when the power is off.
qd DEVICE INDEX switch
Set the device index number of the projector when
using multiple projectors. You can set the numbers
between “01” and “99.” It is set to “01” at the factory.
You can also set the group index number in the menu
for system setup.
Note
Do not set the device index number to “00.”
If you do, the projector will not operate with the
Remote Commander.
You can operate the projector with the keys on the
control panel of the projector but the connected
equipment cannot be operated with the keys on the
control panel.
qf
REMOTE connectors
Used to expand system capability.
RS-232C/RS-422A select switch: Selects according
to the interface connected to the RS-232C/422A
connector.
RS-232C/422A connector (D-sub 9-pin, female):
Connect to a computer to operate the projector
from the computer.
PJ COM IN/OUT connectors (D-sub 9-pin,
female): The connectors conform to the RS-485
standards and are used to expand system
capability for Sony projectors.
For details on connections, see the PJ COM protocol
manual for Sony projectors.