Sony VPD-LE100, Руководство по эксплуатации

Страница: 37 / 44

37
Symptom
“NO INPUT” appears when 15k
RGB or component signal is input.
On-screen displays do not appear.
Color balance is not correct.
The picture is too dark.
The picture is not clear.
Cause
The sync signal is incorrect.
STATUS in the SET SETTING menu is
set to OFF.
Picture has not been adjusted properly.
The color system of the input signal is
not set correctly.
Setting for INPUT-A, INPUT-B, INPUT-
C or INPUT-D in the SIGNAL SELECT
menu is incorrect.
C. BLACK is set to ON.
The lamp is near the end of its life.
Contrast or brightness has not been
adjusted properly.
The picture is out of focus.
Moisture condensation has occurred
on the lens.
Remedy
Input the correct sync singal (composite sync
or sync on G singal (sync on Y for component
singal)).
Set STATUS in the SET SETTING menu to
ON
(page 27).
Adjust the picture (page 23).
Set COLOR SYS in the PICTURE CTRL menu
correctly to match the color system of the input
signal
(page 23).
Set the item correctly according to the input
signal
(page 28).
Set it to OFF in the SET SETTING menu (page
28).
Consult with qualified Sony personnel for the
lamp replacement.
Adjust CONTRAST or BRIGHT in the
PICTURE CTRL menu properly
(page 23).
Adjust the focus
(page 21).
Leave the projector for about two hours with
the power on.
Troubleshooting
Remote Commander/Keys on the control panel
Symptom
The Remote Commander does not
work.
The wireless Remote Commander
does not function.
When you press the ZOOM, SHIFT
or FOCUS key, “LENS CONTROL
is locked! Do you wish to unlock ?”
appears.
Cause
The batteries are exhausted.
The remote commander cable is
connected to the Remote Commander
although you are using it as a wireless
Remote Commander.
The fluorescent lamp influences on the
remote control detector.
You have selected a wrong index
number.
You have set the index number to “00.”
The SIRCS RECEIVER setting is not
correct.
The lens control function is locked.
Remedy
Replace the batteries with new ones (page 16).
Disconnect the remote commander cable.
Change the setting of SIRCS RECEIVER in the
SET SETTING menu
(page 28).
Select the correct index number (pages 28
and 33).
Select the correct index number (pages 28
and 33).
Change the setting of SIRCS RECEIVER in the
SET SETTING menu
(page 28).
Consult with qualified Sony personnel.