13
Changing Settings Using the Front Panel
Changing Settings Using the Front Panel
Display when the unit is powered on
When the unit is powered on, the display window
shows the message “Welcome to SONY MPEG
World!” for about two seconds (initial screen).
After about 2 seconds have elapsed, this changes to the
STATUS screen.
• Display for sdi_to_asi mode, tx-rx mode, tx-rx (cm)
mode, and sdti-cp_to_asi mode: “video_rate: nnn,
ts_rate: nnn”
• Display for asi_to_sdi mode and asi_to_sdti-cp mode:
“program_no = nnn”
To change the mode setting
1
Press the MENU button.
The MENU button lights, and the menu appears in
the display window.
2
Press the
V
key, to display the “B:mode” menu.
3
Press the ENTER button.
The ENTER button and the mode indication flash.
4
With the
v
or
V
key, select the mode. You can
also use the
B
and
b
keys.
5
Press the ENTER button.
The ENTER button goes off, and the unit is set to
the selected mode.
To cancel a change of mode setting
Without pressing the ENTER button, press the
MENU button.
6
Press the MENU button.
The MENU button goes off, and this exits the
menus.
To change ts_rate
1
Press the MENU button.
The MENU button lights, and the menu appears in
the display window.
2
Press the
V
key, to display “C:Setup.”
3
Press the
B
key.
4
With the
v
and
V
keys, display “C061:ts_rate.”
The lower part of the display window shows the
current setting value.
5
Press the ENTER button.
The “manual” indication and the ENTER button
flash.
6
With the
v
and
V
keys, select the setting value.
When “auto” is selected
1
Press the ENTER button.
The ENTER button goes off, and the setting
changes to an automatically calculated value for
ts_rate.
An “A” is appended after the setting value.
When “manual” is selected
1
Press the ENTER button.
The cursor flashes on the setting value.
2
Enter the setting value with the
v
and
V
keys.
To move from one digit to another use the
B
and
b
keys.
You can specify ts_rate in increments of 1 kbps.
Parameter unit: Mbps
3
Press the ENTER button.
The ENTER button goes off, the setting is
changed, and “**” appears.
MENU
ENTER
RESET
MENU button
ENTER button
Cursor keys
